So I just loaded the latest APIC-EM ISO and the webpage will not load.

[amhughes1]

I just installed the GA version of the APIC-EM and it seems to install correctly runs through the wizard and everything but after the services start the Web UI does not load I don't see the webpage at all.  We had the CA2 release previously on this VM and it worked like a charm, has anyone else seen this issue or have any ideas?  I have tried blowing away the VM and starting over but same result.

Thanks,

Adam !

[yawming · Accepted solution]

Is your UI service running ?

You can check it out by going to https://controllerIP:14141 (port 14141) use the same credential as you login to your UI.

[amhughes1]

So I can login and this is what I see under UI

ui

0.9.5.2081

50

https

/

/

9000

how do I know if it is running?  Sorry I am a newbie to this stuff

[yawming]

Is it green and say running at the bottom ? choose overview view.

[amhughes1]

It looks like most of the services were not turned on so I am growing them now we will see if that fixes it.

[amhughes1]

That did it thanks for you help it works now.

[yawming]

[steffen.bodensohn@heraeus.com]

Hello,

I got the same problm. This is the first time  I installed APIC-EM and now I started every avilable service manually.

Is it correct that every service must be up and running ?

Best regards,

Steffen

[yawming]

We should see all services are running after a successful installation. It's better to get all services running. Make sure to allocate enough memory,cpu and storage when we install it