cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
261
Views
0
Helpful
2
Replies
Beginner

Unable to get a response from Cisco Prime Provisioning API

Hello all,

I'm using Postman to attempt to get a response from Cisco Prime Provisioning, but I'm not having much luck. I'm going along with the below documentation from Cisco, however, it does not clearly state the URL I should use or what type of Auth either. This is what I have done so far. URL = https://ip-address and I've tried using Basic Auth with the globaladmin account. Apparently, Prime is supposed to fail at first, then send you back the session id, but it fails and fails

Any help would be much appreciated! Thanks!

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Cisco Employee

Re: Unable to get a response from Cisco Prime Provisioning API

This is not the right community for this question.  This community is specifically for the Prime Infrastructure API.  I think your best bet for this question is the Prime Collaboration Management support forum.

2 REPLIES 2
Beginner

Re: Unable to get a response from Cisco Prime Provisioning API

Highlighted
Cisco Employee

Re: Unable to get a response from Cisco Prime Provisioning API

This is not the right community for this question.  This community is specifically for the Prime Infrastructure API.  I think your best bet for this question is the Prime Collaboration Management support forum.

Content for Community-Ad
August's Community Spotlight Awards