WAE7.2 Collect topo-igp-nimo

[luklu]

Hello Team ,

i am using WAN Engine Automation 7.2 and below is the configuration,

nimo topo-igp-nimo network-access wan_network_access
nimo topo-igp-nimo igp-config 0
seed-router dfw10-wxbb-rr01
igp-protocol isis
!
nimo topo-igp-nimo collect-interfaces true
nimo topo-igp-nimo node-filter node-filter "IGNORE FILTER"
nimo topo-igp-nimo advanced interfaces ip-guessing safe
nimo topo-igp-nimo advanced interfaces lag true
nimo topo-igp-nimo advanced interfaces lag-port-match complete
nimo topo-igp-nimo advanced interfaces get-physical-ports true

Question,

why can not get some interface name(refer to below screenshot) ? is there any special configuration?

[Alex Stevenson]

Hello @luklu,

According to Cisco WAE 7.2.1 User Guide - Chapter: Network Interface Modules (NIMOs), these are the available commands:

BGP-LS XTC Advanced Options

This topic describes advanced options available when running BGP-LS topology collection using XTC.

Option	Description
nodes
remove-node-suffix	Remove node suffixes from node names if the node contains this suffix. For example, 'company.net' removes the domain name for the network.
nodes | interfaces
net-recorder	If set to 'record', SNMP messages to and from the live network are recorded in the net-record-file as discovery runs. Used for debugging.
net-record-file	Directory in which to save the SNMP record. Used for debugging.
interfaces
find-parallel-links	Find parallel links that aren't in the IGP database (when IS-IS TE extensions aren't enabled).
ip-guessing	Level of IP address guessing to perform for interfaces that are not present in the topology database. (Used when IS-IS TE extensions aren't enabled.) off—Perform no guessing. safe—Choose guesses that have no ambiguity. full—Make best-guess decisions when there is ambiguity.
lag	Enable LAG discovery of port members.
lag-port-match	Determine how to match local and remote ports in port circuits. exact—Match based on LACP. none—Do not create port circuits. guess—Create port circuits to match as many ports as possible. complete—Match based on LACP first, and then try to match as many as possible.
cleanup-circuits	Remove circuits that don't have IP addresses associated to interfaces. Circuit removal is sometimes required with IS-IS databases to fix IS-IS advertising inconsistencies.
copy-descriptions	Copy physical interface descriptions to logical interfaces if there is only one logical interface and its description is blank.
get-physical-ports	Collect L3 physical ports for Cisco. Collect physical ports if there is an L1 connection underneath.
min-prefix-length	Minimum prefix length to allow when finding parallel links. All interfaces with equal or larger prefix lengths (but less than 32) are considered.
min-guess-prefix-length	Minimum IP guessing prefix length. All interfaces with equal or larger prefix lengths are considered.