Comments
Level 1
Level 1

Hello,

Congrat on your video. It was very helpful. CAn you provide some information how to monitor the temperature of ios-xe devices like ASR903 via OID?

I am trying via OID CISCO-ENVMON-MIB:ciscoEnvMonTemperatureStatusTable but it says is not supported. Or there is another oid that i can poll what is shown at show environment?

Thank you,

MEry

Hi, Did you get the answer for temperature OID query for IOS XE Devices? Please share it if you have located  the answer. I do have the same challenge.

Thanks in anticipation.

Get the descriptions from .1.3.6.1.2.1.47.1.1.1.1.2 And then poll .1.3.6.1.4.1.9.9.91.1.1.1.1.4 (entSensorValue) .1.3.6.1.4.1.9.9.91.1.1.1.1.5 (entSensorStatus) .1.3.6.1.4.1.9.9.91.1.2.1.1.4 (entSensorThresholdValue) To give you a few examples.