I have been trying to migrate a TCL IVR script from 2900 to ISR router for days, but the router show a lot of erros.
On debug process the most part of the functions are not compatible with the new platform.
The script is very simple with options and make calls.
What do you suggest ?
Solved! Go to Solution.
I'm trying to migrate my tcl from pri to sip trunk like that.
New gateway will be replace with ISR4331 with sip trunk instead of pri as follows. What i need to change on tcl scrip. I was open another post for that case just I want to know do i need to modify my TCL.
ITSP....sip trunk....4331....sip trunk.....CUCM...ip phone...
You were suggested following dp previously..
dial-peer voice 200 voip
session protocol sipv2
incoming called-number 798888
No, no. This prompt is ok.
When I choose a option the script forward the caller to a destination. During this process the caller stay in mute until the destination answer the call. I would like to enable a calling tone for caller listen while he wait a answer..
Caller should hear ringback.
What is the protocol of incoming/outgoing trunk ?
You can also try
puts "FAZENDO CHAMADA"
leg setup $destination callinfo leg_incoming
playtone leg_incoming tn_ringback
I applied like your suggestion. But it did not fix the problem.
When I call to system I m stay on mute until destination answer the call.