Cisco Bug Discussions

Platform:ASR1000Ver: 17.3.4aSymptom: Similar to bug reported under CSCvh18158 -- no policy/proposal is matched though its specifically configured for peer and multiple ikev2 SA active sessions are established with status Up-idleError:Jun 29 19:32:08....

The ISR1k-4G device shows as out-of-sync and Viptela OS, even though it is running Cisco OS.What could be the root cause of this issue and impacted devices? Do these devices respond to the API calls by vManage?

When the http2 function is enabled in WSA, the Internet hangs. CSCwa18480 - It seems to be related to this bug. I am using this version WSA / version 14.0.3-014  I am not sure which version is affected.I need help. Thank you  

Can anyone help me retrieve my enrolled courses in netacad. All my courses are gone, netacad is displaying 'you've not enrolled in any course". I just have to do my final exam on netacad to get done, but everything is gone. Thank you.

Hello Dearsi have ASR-920-12SZ-A  in my  network suddenly rebooted and found the reload reasonLast reload reason: CPU-HResetanyone know  what this reason means ? Reagards

Hello, attached below is my current network:Now I am not sure if there is a bug or a glitch but when I open this project up for the first time, when I try and ping from PC0 - PC 7 there is a delay message which says: But then after this it works fine...

Hi,I am not a native English speaker. Correct me, if necessary.I have started the packet tracer activities of the introduction to IoT course. In this activity, I have to record the IP Address of the home network in the Home Gateway, then go to the Ta...

 Unfortunately, the problem persists in version 15.2(7)E7. IGMP Query packets (224.0.0.1) sent from the router do not reach all hosts, resulting in loss of multicast traffic to selected hosts. Only disabling the igmp snooping helps.

Also observed with 17.6.3 Primarily affected VRRP (approx. every 2 hours). UDLD affected once a day around the same time. VRRP master stops sending VRRP advertisements (no packet captured by optical tap and no advertisement sent as per the debugging ...

Hello, I'm experiencing a switch WS-C3650-24T reload with the last reason of "Power Failure" but there was no actual power issue. 3650#show versionCisco IOS Software, IOS-XE Software, Catalyst L3 Switch Software (CAT3K_CAA-UNIVERSALK9-M), Version 03....

Is there a way to manual import the CRL through SCP/SFTP if the CDP is not reachable?

We had this exact issue happen three times this morning as we atempted to migrate from really old 3Com switches to brand new 9200 switches. Really interested to see what might be the root cause. Selection of the generated log

I'm sharing this in the hopes that possibly someone has a few miraculous fixes or suggestions or that Cisco will make their APs and AP Software more stable (fix known issues faster e.g. updates that "break" third-party certificates and in turn the 98...