Cisco Bug Discussions

CISCO2911/K9Router was running c2900-universalk9-mz.SPA.151-4.M2.binUpgraded IOS to c2900-universalk9-mz.SPA.151-4.M5.binThere is no RPS installed, and we are getting SNMP alarms that the RPS has failed.The power system is working fine. An incorrect ...

From:  CSCud64601Symptom:Customer cannot dial numbers for France country code - 0033 Conditions:CM BE 3000 dial-plan does not have the pattern for the 0033* dialingLocale - cm-locale-english_united_kingdom_CP-8.6.4.10000-1.cop.sgnPattern available -...

Is there any info available to the bug concenrning versions affected and not affected? My csustomer is influenced with the bug, and SLA agents doesnt work well with it, I need to recommend different SW release.Thanks, David

Would this bug be limited to only a T1 interface as mentioned the bug documentation? I have a customer where the BIND is performed on a LAN subinterface and that is flapping and the customer is losing the BIND. It would appear that it is not only lim...

Our users are really upset about this... hoping to see a fix soon! Any idea when we might see one? Thx

Has anyone ran into this?  In my case it's 7.5(10) ES 4 and the retrieve button on any pg just causes the whole campaign config to crash.No workaround found..Chad

Hi,I'm Getting Error in router from NVRAMwhile accessing below command in privilge 4 loginCTS-SEC-CBE#sh configurationUsing 14350 out of 262144 bytes%Error opening nvram:/startup-config (Permission denied)The error not observed while executing the co...

  Hi,    I observe the same bug issue on 8.4(4)5 in multicontext configuration mode. Can you please comment is the same workaround can be implemented in this situation ?

Hello,I updated Cisco CP Express from 1,3 to 2.5 on one of my Cisco 857 routers. I noticed that there was an icon of for firewall.Do you know why Firewall option has disappeared after Cisco CP Express upgrade? How to get it back?thanks in advanceDrag...

An alternate workaround for this issue is to use a 1 or 2 port VWIC (VWIC-1MFT-T1 or VWIC-2MFT-T1) in the WIC slot on the IAD2432.  When you configure the PRI on the WIC interface, it initializes without error.

Someone had this problem? The ASA reboot unexectedly? and how can solve this problem?