cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
410
Views
0
Helpful
0
Replies
Highlighted

CSCsq07109 - Crypto self test messages shown during startup

Hi, 

 

My C6504 reboots after experiencing this bug;

 

see logs below. 

 

SWDISTMETRO23F#sh ver
Cisco IOS Software, s3223_rp Software (s3223_rp-ADVIPSERVICESK9_WAN-M), Version 12.2(33)SXI14, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2014 by Cisco Systems, Inc.
Compiled Wed 03-Sep-14 23:45 by prod_rel_team

ROM: System Bootstrap, Version 12.2(17r)SX3, RELEASE SOFTWARE (fc1)

SWDISTMETRO23F uptime is 1 day, 1 hour, 39 minutes
Uptime for this control processor is 1 day, 1 hour, 38 minutes
Time since SWDISTMETRO23F switched to active is 1 day, 1 hour, 37 minutes
System returned to ROM by power on (SP by reload)
System restarted at 11:19:22 PYST Sun Jan 6 2019
System image file is "sup-bootdisk:/s3223-advipservicesk9_wan-mz.122-33.SXI14.bin"
Last reload reason: ACL Deny Test Failure

 

This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.

A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html

If you require further assistance please contact us by sending email to
export@cisco.com.

cisco WS-C6504-E (R7000) processor (revision 2.0) with 458752K/65536K bytes of memory.
Processor board ID FOX1509GR79
R7000 CPU at 300Mhz, Implementation 0x27, Rev 3.3, 256KB L2, 1024KB L3 Cache
Last reset from power-on
6 Virtual Ethernet interfaces
57 Gigabit Ethernet interfaces
1915K bytes of non-volatile configuration memory.

65536K bytes of Flash internal SIMM (Sector size 512K).
Configuration register is 0x2102

SWDISTMETRO23F#sh log
Syslog logging: enabled (0 messages dropped, 3 messages rate-limited, 0 flushes, 0 overruns, xml disabled, filtering disabled)

No Active Message Discriminator.

 

No Inactive Message Discriminator.


Console logging: level debugging, 51 messages logged, xml disabled,
filtering disabled
Monitor logging: level debugging, 0 messages logged, xml disabled,
filtering disabled
Buffer logging: level debugging, 51 messages logged, xml disabled,
filtering disabled
Exception Logging: size (4096 bytes)
Count and timestamp logging messages: disabled
Persistent logging: disabled

No active filter modules.

ESM: 0 messages dropped

Trap logging: level informational, 49 message lines logged
Logging to 192.168.10.161 (udp port 514, audit disabled,
link up),
49 message lines logged,
0 message lines rate-limited,
0 message lines dropped-by-MD,
xml disabled, sequence number disabled
filtering disabled

Log Buffer (8192 bytes):

*Jan 6 13:36:23.223: RP: Currently running ROMMON from S (Gold) region
*Jan 6 13:36:24.011: %SPANTREE-5-EXTENDED_SYSID: Extended SysId enabled for type vlan. The Bridge IDs of all active STP instances have been updated, which might change the spanning tree topology
*Jan 6 09:36:28.491: %SYS-6-CLOCKUPDATE: System clock has been updated from 13:36:28 UTC Sun Jan 6 2019 to 09:36:28 PYST Sun Jan 6 2019, configured from console by console.
*Jan 6 10:36:28.495: %SYS-6-CLOCKUPDATE: System clock has been updated from 09:36:28 PYST Sun Jan 6 2019 to 10:36:28 PYST Sun Jan 6 2019, configured from console by console.
*Jan 6 10:36:30.792: %SYS-5-CONFIG_I: Configured from memory by console
*Jan 6 10:36:30.848: %PARSER-5-CFGLOG_LOGGEDCMD: User:console logged command:access-list 199 permit icmp host 10.10.10.10 host 20.20.20.20
*Jan 6 10:36:30.852: %PARSER-5-CFGLOG_LOGGEDCMD: User:console logged command:crypto map NiStTeSt1 10 ipsec-manual
*Jan 6 10:36:30.852: %PARSER-5-CFGLOG_LOGGEDCMD: User:console logged command:match address 199

*Jan 6 10:36:30.852: %PARSER-5-CFGLOG_LOGGEDCMD: User:console logged command:set peer 20.20.20.20

*Jan 6 10:36:30.852: %PARSER-5-CFGLOG_LOGGEDCMD: User:console logged command:exit
*Jan 6 10:36:31.880: %PARSER-5-CFGLOG_LOGGEDCMD: User:console logged command:no access-list 199
*Jan 6 10:36:31.888: %PARSER-5-CFGLOG_LOGGEDCMD: User:console logged command:no crypto map NiStTeSt1
*Jan 6 10:36:35.376: %SYS-5-RESTART: System restarted --
Cisco IOS Software, s3223_rp Software (s3223_rp-ADVIPSERVICESK9_WAN-M), Version 12.2(33)SXI14, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2014 by Cisco Systems, Inc.
Compiled Wed 03-Sep-14 23:45 by prod_rel_team
*Jan 6 10:36:35.384: %SSH-5-ENABLED: SSH 2.0 has been enabled
*Jan 6 10:05:50.755: %SYS-SP-3-LOGGER_FLUSHED: System was paused for 00:00:00 to ensure console debugging output.
*Jan 6 13:36:18.191: %SPANTREE-SP-5-EXTENDED_SYSID: Extended SysId enabled for type vlan. The Bridge IDs of all active STP instances have been updated, which might change the spanning tree topology
*Jan 6 13:36:34.532: %SYS-SP-5-RESTART: System restarted --
Cisco IOS Software, s3223_sp Software (s3223_sp-ADVIPSERVICESK9_WAN-M), Version 12.2(33)SXI14, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2014 by Cisco Systems, Inc.
Compiled Thu 04-Sep-14 00:23 by prod_rel_team
*Jan 6 13:36:34.560: SP: Currently running ROMMON from S (Gold) region
*Jan 6 13:36:34.976: %SYS-SP-6-BOOTTIME: Time taken to reboot after reload = 345 seconds
*Jan 6 13:36:34.696: %OIR-SP-6-INSPS: Power supply inserted in slot 1
*Jan 6 13:36:34.700: %C6KPWR-SP-4-PSOK: power supply 1 turned on.
*Jan 6 13:36:34.764: %OIR-SP-6-INSPS: Power supply inserted in slot 2
*Jan 6 10:36:35.864: %SYS-6-LOGGINGHOST_STARTSTOP: Logging to host 192.168.10.161 port 514 started - CLI initiated
*Jan 6 13:36:34.768: %C6KPWR-SP-4-PSOK: power supply 2 turned on.
*Jan 6 13:36:34.772: %C6KPWR-SP-4-PSREDUNDANTBOTHSUPPLY: in power-redundancy mode, system is operating on both power supplies.
*Jan 6 10:36:37.468: %SNMP-5-COLDSTART: SNMP agent on host SWDISTMETRO23F is undergoing a cold start
*Jan 6 10:36:40.701: %DIAG-SP-6-RUN_MINIMUM: Module 1: Running Minimal Diagnostics...
*Jan 6 10:37:05.044: %DIAG-SP-6-DIAG_OK: Module 1: Passed Online Diagnostics
*Jan 6 10:37:06.112: %MLSM-6-MMLS_MODE_CHANGE: MMLS: Replication Mode Changed to Ingress mode (Oir event or MMLS enabled)
*Jan 6 10:37:06.132: %MFIB_CONST_RP-6-REPLICATION_MODE_CHANGE: Replication Mode Change Detected. Current system replication mode is Ingress
*Jan 6 10:37:06.448: %SNMP-5-MODULETRAP: Module 1 [Up] Trap
*Jan 6 10:37:06.468: %OIR-SP-6-INSCARD: Card inserted in slot 1, interfaces are now online
*Jan 6 10:37:39.916: %DIAG-SP-6-RUN_MINIMUM: Module 3: Running Minimal Diagnostics...
*Jan 6 10:37:49.724: %DIAG-SP-6-DIAG_OK: Module 3: Passed Online Diagnostics
*Jan 6 10:37:52.252: %SNMP-5-MODULETRAP: Module 3 [Up] Trap
*Jan 6 10:37:52.968: %OSPF-5-ADJCHG: Process 10, Nbr 192.168.0.52 on GigabitEthernet1/2 from LOADING to FULL, Loading Done
*Jan 6 10:37:52.256: %OIR-SP-6-INSCARD: Card inserted in slot 3, interfaces are now online
*Jan 6 10:37:53.276: %OSPF-5-ADJCHG: Process 10, Nbr 192.168.0.43 on GigabitEthernet1/1 from LOADING to FULL, Loading Done
.Jan 6 11:21:24.175: %BGP-5-ADJCHANGE: neighbor 10.12.3.1 Up
.Jan 6 11:21:51.099: %PIM-5-NBRCHG: neighbor 10.12.6.1 UP on interface Tunnel1
.Jan 6 11:21:51.127: %PIM-5-NBRCHG: neighbor 10.12.3.1 UP on interface Tunnel0
.Jan 6 11:21:52.083: %TDP-5-INFO: Tunnel0: LDP started
.Jan 6 11:21:52.083: %TDP-5-INFO: Tunnel1: LDP started
.Jan 6 11:21:52.211: %LDP-5-NBRCHG: LDP Neighbor 192.168.0.147:0 (1) is UP
.Jan 6 11:21:52.215: %LDP-5-NBRCHG: LDP Neighbor 192.168.0.137:0 (2) is UP
.Jan 6 11:22:00.407: %OSPF-5-ADJCHG: Process 10, Nbr 192.168.0.50 on GigabitEthernet3/1 from LOADING to FULL, Loading Done
Jan 6 11:22:34.599: %BGP-4-VPN_NH_IF: Nexthop 10.12.3.11 may not be reachable from neigbor 10.12.3.1 - not a loopback

 

We upgraded from SXI6 -> SXI14 to prevent this from happening but apparently it didn't get fixed.

0 REPLIES 0