06-26-2018 05:01 AM - edited 03-20-2019 10:15 PM
Hi,
I am getting CDP mismatch error between SG300 and SG550X and I am assuming this happening due to this bug.
My configuration as below:
SG550X:
interface GigabitEthernet1/0/19
storm-control broadcast level 10 trap
storm-control unicast level 10 trap
storm-control multicast level 10 trap
channel-group 6 mode auto
switchport mode trunk
!
interface GigabitEthernet2/0/19
storm-control broadcast level 10 trap
storm-control unicast level 10 trap
storm-control multicast level 10 trap
channel-group 6 mode auto
switchport mode trunk
!
interface Port-Channel6
switchport mode trunk
switchport trunk native vlan 2
switchport trunk allowed vlan remove 1
and SG300 configuration as below:
interface gigabitethernet27
storm-control broadcast enable
storm-control include-multicast unknown-unicast
channel-group 1 mode auto
!
interface gigabitethernet28
storm-control broadcast enable
storm-control include-multicast unknown-unicast
channel-group 1 mode auto
!
interface Port-channel1
switchport trunk allowed vlan add 10,20,50
switchport trunk native vlan 2
Am I correct? Is it bug not fixed yet?. Current running version is: 2.3.5.63
Regards,
Deepak Kumar
Solved! Go to Solution.
06-26-2018 06:03 AM
The issue has identified. SG300 is running with buggy Image "1.3.5.58".
Regards,
Deepak Kumar
06-26-2018 06:03 AM
The issue has identified. SG300 is running with buggy Image "1.3.5.58".
Regards,
Deepak Kumar
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: