CSCve12817 - percentSNMP-SW1-3-RESPONSE_DELAYED processing GetNext of ciscoFlashFileEntry
Hello good day,
A query please, according to this Bug% SNMP-SW1-3-RESPONSE_DELAYED: processing GetNext of ciscoFlashFileEntry, from what I understand it means that some object can exceed the threshold limit that by default is (2000ms), and it is informed to the user that the response is delayed, and that it has no impact on the network.
The question is: how can I modify SNMP parameters on the equipment so that the log disappears from the equipment?
Re: CSCve12817 - percentSNMP-SW1-3-RESPONSE_DELAYED processing GetNext of ciscoFlashFileEntry
There is a command to increase the timeout.
snmp monitor response [msec]
Depending on how long this OID is being delayed in your setup, you may see issues with your NMS station. For example, if the ciscoFlashFileEntry OID takes more than say 30 seconds, then subsequent OIDs could be dropped or, in some cases, the NMS server, getting no response, will just timeout completely and declare the device "dead". So it may not be as cosmetic as you think. I imagine the NMS timeout is on the order of 30 seconds though, not just 2.
Product Returns and Replacement (PRR) Tool users within TAC are encouraged to utilize the Customer Handoff feature to allow customers to complete the RMA. This will reduce the volume of customers from having to contact an LSC agent or TAC Engin...
Effective March 22nd, 2020, the Chat feature will be enabled in the Product Returns and Replacement (PRR) tool.
This feature allows PRR users to initiate chats with Cisco's Logistics Service Center agents (LSC) located across the globe. LSC agents s...
Effective March 8th, 2020, TAC Engineers who initiate RMAs in PRR will be required to enter a valid SR number or the user will not be allowed to proceed with RMA creation.
TAC users will only have the ability to create RMA in PRR starting with (1) the SN ...
Users of Cisco's PRR (Product Returns and Replacement) tool will have a new capability following the March 8th, 2020 release.
While the capability to cancel an RMA created in PRR that are in draft state has been available for some time, following the late...
Users of Cisco's PRR (Product Returns and Replacement) tool will notice a new requirement following the March 8th, 2020 release.
When an eligible labor RMA is created, the RMA creator will be required to add a Technical Contact that the Field Engineer wil...