CSCve98689 - Repeated CDP-4-DUPLEX_MISMATCH is observed when 1852 and 3802 APs are connected to 3850 switch.

[misho23]

Hello,

the same symptoms occurred on the switch WS-C3650-48TS and connected AP Air-AP2802E-E-K9.

Duplex on both devices is same - FULL.

Workaround - disable CDP on the switch interface.

[Meheretab Mengistu]

Hi,

Did you try rebooting the switch? Could you share the interface configuration you have on the switch?

[misho23]

Hi,

the switch was rebooted 9 weeks ago and now is not possible to reboot it again.

interface GigabitEthernetX/X/XX
 description AP
 switchport access vlan XXX
 no cdp enable
 spanning-tree portfast
 spanning-tree bpduguard enable

[misho23]

Hi,

the switch was rebooted 9 weeks ago and now is not possible to reboot it again.

interface GigabitEthernetX/X/XX
 description AP
 switchport access vlan XXX
 no cdp enable
 spanning-tree portfast
 spanning-tree bpduguard enable

[Meheretab Mengistu]

I believe the speed and duplex is negotiated between the switch and the APs. Did you try manually configuring the duplex to Full and enable CDP?

[james.a.bond]

Same issue with same workaround vWLC Version 8.5.120.0 WS-C3850-48U and 2802i Access Points. Tried every to set speed 1000 duplex full on switchports before adding to etherchannel. Tried adding one port at a time...workaround resolves issue. Definitely a bug. Thanks for the heads up and workaround +5