Hello. I have a large number of switches CBS350-24FP-4X and CBS350-48P-4X with sw version 3.1.1.7 and 3.0.0.69 where the same problem occurs.
After some time, the switch swears that the consumption of the budget is exceeded and disabled poe ports.
Moreover, the problem affects completely different switches with a different amount of connected equipment. From 3 to 8 device WiFi AP (c9120)
The error comes out even on empty ports.
This issue has a huge impact on my network.
04-May-2022 12:03:22 :%HAL_config_poe-I-OVLPort: PD connected to Port gi1/0/21 requires more power than it should. Please disconnect it
04-May-2022 02:23:20 :%HAL_config_poe-I-PSEPortStatus: Pse Port gi1/0/8 is delivering power to the PD
04-May-2022 02:23:07 :%HAL_config_poe-I-PSEPortStatus: Pse Port gi1/0/8 is not delivering power to the PD
04-May-2022 02:23:06 :%HAL_config_poe-I-OVLPort: PD connected to Port gi1/0/8 requires more power than it should. Please disconnect it
Interface Admin Oper Power (W) Class Device Priority
---------- ---------- ----------- ----------------- ----- -------------- --------
gi1/0/1 Never Fault 0.0 0 low
gi1/0/2 Never Fault 0.0 0 low
gi1/0/3 Never Fault 0.0 0 low
gi1/0/4 Never Fault 0.0 0 low
gi1/0/5 Never Fault 0.0 0 low
gi1/0/6 Never Fault 0.0 0 low
gi1/0/7 Never Fault 0.0 0 low
gi1/0/8 Auto On 8.872 4 WiFi-AP critical
gi1/0/9 Never Fault 0.0 0 low
gi1/0/10 Never Fault 0.0 0 low
gi1/0/11 Never Fault 0.0 0 low
gi1/0/12 Never Fault 0.0 0 low
gi1/0/13 Never Fault 0.0 0 low
gi1/0/14 Never Searching 0.0 0 low
gi1/0/15 Never Fault 0.0 0 low
gi1/0/16 Auto On 8.685 4 WiFi-AP critical
gi1/0/17 Never Fault 0.0 0 low
gi1/0/18 Never Fault 0.0 0 low
gi1/0/19 Never Fault 0.0 0 low
gi1/0/20 Never Fault 0.0 0 low
gi1/0/21 Auto On 8.963 4 WiFi-AP critical
gi1/0/22 Never Fault 0.0 0 low
gi1/0/23 Never Fault 0.0 0 low
gi1/0/24 Never Fault 0.0 0 low
