cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
736
Views
5
Helpful
1
Replies

Port-Channel goes down when traffic increases

RV_Network
Level 1
Level 1

We have a strange error who occurs when the traffic increases on the network. Every sunday we have a larger server backup job, where the  traffic increases. Everytime the port-channel goes down for just a secound. Have anyone seen that before?

 

This is the log message; 

21:37:54 %ETH_PORT_CHANNEL-5-FOP_CHANGED: port-channel3: first operational port changed from Ethernet1/54/1 to none
21:37:54 %ETH_PORT_CHANNEL-5-PORT_DOWN: port-channel3: Ethernet1/54/1 is down
21:37:54 %ETHPORT-5-IF_DOWN_PORT_CHANNEL_MEMBERS_DOWN: Interface port-channel3 is down (No operational members)
21:37:54 %ETHPORT-5-IF_DOWN_LINK_FAILURE: Interface Ethernet1/54/1 is down (Link failure)
21:37:54 %ETHPORT-5-IF_DOWN_PORT_CHANNEL_MEMBERS_DOWN: Interface port-channel3 is down (No operational members)
21:37:56 %ETHPORT-5-SPEED: Interface Ethernet1/54/1, operational speed changed to 1 Gbps
21:37:56 %ETHPORT-5-IF_DUPLEX: Interface Ethernet1/54/1, operational duplex mode changed to Full
21:37:56 %ETHPORT-5-IF_RX_FLOW_CONTROL: Interface Ethernet1/54/1, operational Receive Flow Control state changed to off
21:37:56 %ETHPORT-5-IF_TX_FLOW_CONTROL: Interface Ethernet1/54/1, operational Transmit Flow Control state changed to off
21:37:56 %ETHPORT-5-SPEED: Interface port-channel3, operational speed changed to 1 Gbps
21:37:56 %ETHPORT-5-IF_DUPLEX: Interface port-channel3, operational duplex mode changed to Full
21:37:56 %ETHPORT-5-IF_RX_FLOW_CONTROL: Interface port-channel3, operational Receive Flow Control state changed to off
21:37:56 %ETHPORT-5-IF_TX_FLOW_CONTROL: Interface port-channel3, operational Transmit Flow Control state changed to off
21:38:02 %ETH_PORT_CHANNEL-5-PORT_UP: port-channel3: Ethernet1/54/1 is up
21:38:02 %ETH_PORT_CHANNEL-5-FOP_CHANGED: port-channel3: first operational port changed from none to Ethernet1/54/1
21:38:02 %ETHPORT-5-IF_UP: Interface Ethernet1/54/1 is up in mode trunk
21:38:02 %ETHPORT-5-IF_UP: Interface port-channel3 is up in mode trunk
22:32:58 %USER-2-SYSTEM_MSG: can't dlsym ssnmgr_need_to_buffer_command: please link this binary with ssnmgr.so! - snmpmib_proc

 

 

1 Reply 1

cisconimda
Level 1
Level 1

Did you resolve this.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: