EX's and DX's

[vtc.cjtf.hoa2]

Hello to everyone my shop has been tasked for the future of adding our EX90/60's and new DX's to the Cisco call manager.

I have search and could not find any information on this. But what I did find was for this to work other endpoints must also have

their system added into the call manager, thanks for any information.

[Wayne DeNardi]

You will first need to make sure that your CUCM is up to date and has support for the endpoints you want to add, ie, you will need at least version 9.1(2) of CUCM to support the DX80: The CUCM_FAQ might be helpful for you.

If you have further queries, they would be better placed in the Unified Communications section of the forums where the CUCM is more actively discussed than in the Cafe.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.