cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
65
Views
0
Helpful
0
Replies
Highlighted
Beginner

Nat-xlate-failed When trying to do a traceroute to 8.8.8.8

I am new to cisco's so I am assuming I made a simple mistake in the setup of my cisco ASA 5506 when I use the packet tracer I get this output 

 packet-tracer input inside_1 icmp 192.168.2.200 0 0 8.8.8.8

Phase: 1
Type: ACCESS-LIST
Subtype:
Result: ALLOW
Config:
Implicit Rule
Additional Information:
MAC Access list

Phase: 2
Type: ROUTE-LOOKUP
Subtype: Resolve Egress Interface
Result: ALLOW
Config:
Additional Information:
found next-hop A.B.C.D using egress ifc  outside

Phase: 3
Type: NAT
Subtype:
Result: ALLOW
Config:
object network obj_any1
 nat (inside_1,outside) dynamic interface
Additional Information:

Phase: 4
Type: NAT
Subtype: per-session
Result: ALLOW
Config:
Additional Information:

Phase: 5
Type: IP-OPTIONS
Subtype:
Result: ALLOW
Config:
Additional Information:

Phase: 6
Type: NAT
Subtype: per-session
Result: ALLOW
Config:
Additional Information:

Phase: 7
Type: IP-OPTIONS
Subtype:
Result: ALLOW
Config:
Additional Information:

Result:
input-interface: inside_1
input-status: up
input-line-status: up
output-interface: outside
output-status: up
output-line-status: up
Action: drop
Drop-reason: (nat-xlate-failed) NAT failed

I attached the config file. I am at a loss. I have tried a couple other forms but none of them worked. including some lines that you will see in my config file like

icmp unreachable rate-limit 1 burst-size 1
icmp permit any echo-reply outside
icmp permit any time-exceeded outside
icmp permit any unreachable outside
icmp permit any inside_1
icmp deny any outside
CreatePlease to create content
Content for Community-Ad
Cisco Community April 2020 Spotlight Award Winners