Cisco Catalyst Center

Hello, all! I have read a lot of documentation about DNA but still have some questions. 1) What is the purpose of using underlay/overlay conception in SD-ACCESS? The only reason i see is to allow any devices not change its IP if they change their loc...

Here's your chance to register for the DNAC Installation/Deployment workshop happening this Thursday at 8 a.m. GMT / 4 p.m. SGT. If you can't make it this week, then no worries! This workshop happens every Thursday! So make sure to check your calend...

CSCvi01378 workaround not working for DNAC, anyone has any other workaround ? Its disappointing and frustrating that the products hits a bug even before you get it up and running.

I am new to DNA Center and I noticed in the documentation reference is made to Wired and Wireless access but no mention of VPN/Remote Access.   Is there a technical reason that VPN/Remote Access is not included or is the support slated for the future...

We have DNA lab with various use cases. We now want to train other engineers and let them play around with the lab. Can all the fabric configurations be restored using APIs ? It will be great if we can orchestrate the complete final working state of ...

What does it mean that all these devices are DNA supported?    https://www.cisco.com/c/dam/en/us/solutions/collateral/enterprise-networks/digital-network-architecture/brochure-c02-738188.pdf   what does opendns/umbrella play into DNA?  anywhere it ex...

Hello, If i wanted to connect a high-speed end-system to the fabric, for example, using a 40GE Access port, what are my options ? 1) Do i need to use 2x 9300 in stack with a 2x dual 40GE network modules ? (2 links for uplink to Fabric and two links f...

Hello Community, I am new to Digital Network Architecture technology and I have a couple of questions:What are the protocols that interact between fabric devices / ISE / DNA Center?Can you run DNA Center on VM?Thank you for your reply- John

Hi folks, after enabling SRIOV on the 10g interface of the CSP 2100, the interface shows down. This is with both the modes - veb and vepa. The interface is connected to an ACI leaf switch. Any idea why this would happen? thnx