Cisco Catalyst Center

Under assurance I can't see any performance statistic, for snmp, netflow, capwap-control, dns, auth-service, db-service, dhcp, cisco-collaboration and netbios-ns Any suggestions ?

I'm having trouble setting up a lab environment for Cisco DNA Center. We have the .iso file, but whenever we try to install it, even though the UI gets installed, a bunch of packages, like netwwork-visibility and most of the NDP-packages, as well as ...

Sharing a recent experience for a point of reference should someone encounter similar issues. In our environment we run a 3 node DNAC cluster currently on version 1.3.1.3. The issue identified was that DNAC was reporting services disruption when logg...

hi, i have deployed DNA 1.3.3.3(1). i have discovered 4331 router and 9300 switch. i am facing following issue. 1. when i try to delete (with and without cleanup configuration option selected), it shows that device is being deleted, after some time i...

Hi,Can we add non-cisco switches in DNAC through discovery method for assurance, management and monitoring purposes?Thanks

Hi, I'm trying to install APIC-EM in home lab. I did steps below, but the installation got frozen (see attached printscreen). - provisionned VM on ESXi 5.1- downloaded APIC-EM-1.6.4.30024.iso- attached the iso file on CD/DVD Drive- started VM- frozen...

Is it possible to change the hostname of a DNAC three node cluster once all three nodes are up in HA? Thanks in advance.

I am pretty new to packet tracer and networking as a whole and I am not sure how to configure my DMZ and firewalls. So I have 2 firewalls and a DMZ server between them. Any help will be appreciated. Thanks in advance!

need to reset switch Cisco 9300 to factory settings but i press the mode bottom when plug it in power and waited till i enter the enable mode in the switch and  nothing is happen , is there is steps to do reset