Cisco Catalyst Center

How device configuration can be exported unsanitized so that it can be reused with all credentials e.g. manuel RMA of a device?Any way to switch between unsanitized / sanitized mode for the CLI output in DNAC ?

Hi,We have bunch for 2960x as Edge and 4507-R as Core switches, so is it possible to use DNAC for LAN automation and assurance ?What other benefits we can accomplish from DNA without SD-ACCESS ?Any suggestions ?

hello, my question is : what is the procedure to replace a border node in case of hardware failure? this question since part of the configuration is manual ( ibgp between border) and another is provisionned ("lan automation, ...)  thanks

I'm using DNAC 1.3.1 do the assurance with WLC (3504 - OS version 8.8.125)+ AP (2800).  I configure WLC and AP with Flexconnect + Local switching mode, and under flexconnect group , it automatically enable AVC for all WLAN ssid. I check on WLC (Monit...

hi guyshow can i have a report on cisco prime 3.5 to see how many watts is remain on my switches ?thanks.

Hi, We have a client who is looking to deploy DNA Center plus SD-WAN with Advanced Security in their network. The C1111X-8P-DNA-PM suits their needs however this product is approaching the end-of-sale date. The 1100 series datasheet notes: "The Cisco...

We are designing a SDA setup with 9300 as edge nodes.and 9500 as border node. My question in regards to DNA licensing:- Do we need to buy DNA premier and separate license for ISE appliance  ?- We tried to generate BoM using Cisco CCW portal and it in...

Is the Management port on the DNAC required/recommended for deployment or would the Enterprise port suffice especially in regards to accessing the DNAC GUI? What is best practice? Any downside not using the Management Port on the DNAC?

Hey All,I really need to explicitly understand how each kind of traffic (Intra VN, Inter VN, Outside traffic and etc) flows in Fabric network. I want to know what LISP requests are made, how next-hop is determined, how route determined and etc. Could...

Hello everyone,,I can't seem to find decent information regarding this.DNAC can provision the underlay network, but i find no details on how it does so.Suppose i have a 3-level campus network: Access, Distribution, Core and Border nodes.The underlay ...

Hey All,I have campus network with 9300 and 9500 series switches. one 9500 switch sits as DNS Proxy and all users` DNS addresses are pointed to it and everything works fine. But, if I point it in my other switches it is not working. Even I try to add...

If I have two separate fabric sites separated by an IP transit, but a common VN configured in both (different subnet per site), how do I create one authorization policy in ISE for that users of that vn? When I go to create an authorization result to ...