cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
225
Views
0
Helpful
3
Replies

Migrate from Cisco Prime 3.10 to Catalyst Center 2.3.7 using PDMT

cstcorpsk
Level 1
Level 1

Hi,

 I am trying to migrate from Cisco Prime 3.10 to Cisco Catalyst Center 2.3.7 using the Prime Data Migration tool.  When I run the tool, during the wizard process, it gets stuck in the location selection and none of the locations are showing up. The error that throws up is "Not a valid migration, choose source and destination site.".  

Any suggestions or recommendation is very much appreciated.

Thanks

Suresh