Cisco Cloud Service Router (CSR) for Public Cloud Discussions

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Forum Posts

Hi. I'm trying to deploy a High Availability CSR setup in AWS. The goal is to deploy 2x CSRs in different AZs, then attach Public and Private subnets to that CSR. Each subnet must be created in a different AZ for HA purposes. Also, that is a requirem...

215917
mthomaz by Level 1
  • 2195 Views
  • 1 replies
  • 0 Helpful votes

I'm using an AWS CloudFormation template to launch a CSR 1000 instance. I'd like to use the "UserData" property to define a new user id. The deployment guide provides an example of how to do this. If I launch the instance from the AWS console, and in...

gcote by Level 1
  • 2141 Views
  • 1 replies
  • 0 Helpful votes

Hi all, I'm looking for help on getting Anyconnect SSL VPN setup on a CSR 1000v running IOS XE v3.13.01S. There is an abundance of info on the webvpn style SSL VPN setup but very little on the "crypto ssl" XE SSL VPN style setups. I have been working...

Hi everybody, I've run into strange issue while setting up GRE tunnel between CSR1000v and R881-K9. The tunnel is locally up without " keepalive" but endpoints can not ping each other via tunnel IP. The strange thing is that I tried to setup GRE tunn...

Kwuenph by Level 1
  • 4043 Views
  • 6 replies
  • 0 Helpful votes

hello everyone, I'm trying to use a Cisco AWS CSR 1000 router as a SSL VNP terminator. I'm following instructions from below link (that is not a really well explained guide): http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/sec_conn_sslvpn/configurat...

Hello,   I have a Cisco CSR instance that has the following configured:   > Two SVTI tunnels that point to interface, Gigabit1 > Both the VTIs are "inside" NAT interfaces > Gigabit1 is an "outside" NAT interface > Route: ip route 0.0.0.0 0.0.0.0 Giga...

julietv9 by Level 1
  • 1414 Views
  • 1 replies
  • 0 Helpful votes