cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco UCS Manager Plugin for VMware vSphere HTML Client (Version 3.0(4))

8859
Views
5
Helpful
16
Comments

Cisco has released the 3.0(4) version of the Cisco UCS Manager VMware vSphere HTML client plugin.  The UCS Manager vSphere HTML client plugin enables a virtualization administrator to view, manage, and monitor the Cisco UCS physical infrastructure. The plugin provides a physical view of the UCS hardware inventory on the HTML client. You can perform the following tasks using the plug-in:

• View Cisco UCS physical hierarchy

• View inventory, installed firmware, faults, power and temperature statistics

• Map the ESXi host to the physical server

• Manage firmware for B and C series servers

• View VIF paths for servers

• Launch the Cisco UCS Manager GUI

• Launch the KVM consoles of UCS servers

• Switch the existing state of the locator LEDs

 

Caution: Upgrading the vCenter server might result in loss of plug-in data. Back up the plug-in data before you upgrade. For more information on what you must do before upgrading the vCenter, see the topic Upgrading vCenter in the Cisco UCS Manager Plug-in for VMware vSphere HTML Client User Guide, Release 3.x.

 

New and Changed Features in Release 3.0(4)

  • Support for VMware vSphere HTML Client 7.0

  • Defect fixes

Detailed Release Notes

Software download link

Please see the User Guide for specific information on installing and using the plugin with the vSphere HTML client.

Note: Plugin does not support VMware vSphere HTML Client version 7.0U1

 

New and Changed Features in Release 3.0(3)

  • Defect fixes including a fix for an issue related to User privileges

 

New and Changed Features in Release 3.0(2)

  • Defect fixes.
  • Added a new Fault (F1706) to the Cisco UCS Provider failure conditions list
  • Added support for proactive HA for more than 100 hosts in vCenter

 

The attached registration tool must be used to register the plugin with an existing vSphere HTML client version 6.7 or later.  Here is an example registration tool information screen:

Reg.PNG

Once the plugin is registered and the vSphere HTML client has been restarted (browser re-opened), the Shortcuts menu in the vSphere HTML client will show a Cisco UCS Monitoring icon:
Screen Shot 2018-09-28 at 4.14.11 PM.png

 

UCS Domains can be registered from the Management Center menus by providing access information and credentials for each domain:

Screen Shot 2018-09-28 at 4.15.00 PM.png

 

When a domain is registered, the plugin can be used to perform common configuration operations and monitor UCS domains, servers, and VMs from within the vSphere HTML client:

Screen Shot 2018-09-28 at 4.16.19 PM.png

 

External customers - For any queries/feedback on Cisco UCS Manager plugin for VMware vSphere HTML Client, contact Cisco TAC or add a discussion to the Cisco Developed Integrations sub-space on Cisco Data Center Communities

Comments
Cisco Employee

Hello, @cmturner20, and @Takeshi Kuriyama

Cisco UCS Manager Plugin Version 3.0(4) for VMware vSphere HTML Client supports vCenter version 7.0. The plugin does not support client version 7.0 U1 currently. This behavior will be handled in the upcoming release which will be built with vSphere Client SDK 7.0 U1.

 

Please open a support ticket if this issue is observed in the 7.0 version.

Content for Community-Ad
This widget could not be displayed.