Connect-UCS Failed

[kunal.bhadra1]

Hi All,

I am very new to Cisco UCS and PowerTool. I am not able to login to CIsco UCS manager using powertool. whenever I am typing the following:

PowerTool C:>Connect-UCS 10.x.x.x

It is prompting to enter username and password. But after typing my domain credentials as domainname\username and password, it is giving the following error everytime:

Connect-Ucs : Connect-Ucs: Connection to 10.x.x.x Failed.
At line:1 char:12
+ Connect-Ucs <<<<  10.x.x.x
    + CategoryInfo          : NotSpecified: (:) [Connect-Ucs], Exception
    + FullyQualifiedErrorId : Cisco.Ucs.Cmdlets.ConnectUcs

But with same domain credential I am able to login to UCS manager GUI.

Any help will be much appreciated.

- See more at: https://supportforums.cisco.com/discussion/12501976/connect-ucs-failed#sthash.lkyofupm.dpuf

[ericwill]

On your system, do you have a Web Proxy defined in your control panel? I have seen this specific issue many times where people had a Proxy defined, and the proxy was causing issues. If you have a proxy defined, can you try to turn the proxy off, and try again? Or list the IP in the Proxy configuration in Windows as an IP that will bypass the proxy for communications.

Thanks,

Eric