Missing a PowerTool Command?

[timwilkes]

Hi All,

New to Cisco PowerTool so I apologize if I am just missing something obvious. Googling offered me no obvious answer...

I installed the Powertool 1.2.1 powershell tools and was looking for scripts and commands dealing with powering on/off service profiles.

I found the Get-UcsServerPower cmdlet and verified I could use it with no problem. However, when I went to use Set-UcsServerPower the command wasn't even listed in the module. I checked and rechecked my module, the command was not even found. Has this command been replaced in 1.2.1? What am I missing?

Thanks in advance!

[ericwill]

It's still there in 1.2.1.1 for me:

PS C:\> Get-UcsPowerToolConfiguration

Version InstallDir SupportMultipleDefaultUcs InvalidCertificateAction

[timwilkes]

Thanks, Eric. You pointed me in the right direction!

It turns out I had 1.2.1.0 of powertool, not 1.2.1.1.

Since I can't find a download for 1.2.1.1 from the main powertool download site, I just download 1.3.1.0

Voila! The command is there.

Would be curious to hear Cisco's take on this.

[ericwill · Accepted solution]

Tim:

It was a bug we found in 1.2.1.0, and fixed in 1.2.1.1.

Thanks,

Eric

[timwilkes]

Thanks, again, Eric!