Resolved! DNA node hostname update
Hello, Is it possible to update each DNA node hostname once the cluster is already deployed ? Thx.
Forum Posts
I have a Cisco 5520 Controller that is in the inventory in DNAC but I do not have the access points that are in the WLC showing up in DNAC. WLC 5520= 8.2.190APs= 9130, 1815DNAC= 2.3.5.5-72026
Is it possible to transfer licenses between differing series of switches e.g. from a Catalyst 9406 to Cat 9300, naturally keeping the same subscription level. Thanks
Greetings all,I've been tinkering with DNA Center's AI RRM in some of our buildings and noticed some interesting results in that our wireless network health has degraded, particularly in higher density areas where we have a hospitality unit in each d...
Need some idea like which protocols in backend DNAC use to perform its discovery ,Will it uses SNMP, ICMP and SSH to do the discovery and to access them.
Hi,my configuration validation keeps failing due to cluster interface. I am talking about single node cluster.When I get to configure network adapter #2 (cluster), it says cable status: disconnected although the switcport status it's in connected sta...
Both can ping each other through ICMP, NO FW/ACL in between. The ISE shows available but PXGrid unavailable. External auth works. Both ISE and DNA certs replaced with trusted inter and root. Look fine. Unsure what else to check, as I deleted and re-a...
Can you please confirm that the first nxos software compatible with Cisco DNA is - nxos.10.2(2)And if you can give a link to the best reference information for such upgrade from nxoa.9.3.9Thank you
Resolved! SDA Wireless AP Communication
Hi All, I just want to check on the SDA Wireless AP communication in underlay. we are using Infra (default) vrf for AP subnet and due to our undelay infra design, we have asymmetric routing from Wireless AP subnet to service subnets (DNAC, DHCP, DNS...
Dears,please does anyone know if I can change the DNA IP address and how?
Resolved! Netconf Connection failure
Hi Friends,In my inventory list in DNAC, I have three switches with error Netconf connection failure in manageability column. I checked and did all the things that DNAC suggested. But I still have this error. In addition , I have below log in CLI: 66...
Hi All, we are planning to deploy catalyst centre VA in our environment. can anyone suggest the compute requirement for the same. i Know the compute details are available for AWS instance. can we use the same for on prem deployments as well. Regards,...
Dear all, In my DNAC, I've successfully added my Smart Account credentials (System > Settings > Smart Account). I want to switch my credentials with other credentials but I get the following error: "Smart Account privilege check is failed. Smart Acco...
Hi there,We've got a DNAC for VMware OVA file and in the process of spinning up a VM and have a few questions.I have no previous experience with DNAC nor Prime Infrastructure so apologies in advance if this is somewhat obvious.The OVA comes with 2 NI...
I've found some really good value used 9300s from a reputable used kit supplier (I've bought lots of Dell servers and 3850s from them before).On my 3850s I use service-routing mdns-sd to manage Bonjour between VLANs quite happily (although a little c...
