i have a client who already has the cisco DNAC license and want to implement cisco DNAC on the VM
Forum Posts
Cisco Prime will reach EOS September 29, 2023. The replacement with DNAC. This is a network post and not Collaboration topic. So moving to Network Community. 2.12.0.0 2.12.0.0
Hi Guys,Well I would like to activate 802.11r for my corporate Wifi since our wlan card are compatible with fast-roaming.Configuring this settigs, directly from my WLC9800 is pretty easy, you edit the WLAN, Enable Fast Transition and mark FT+802.1xHo...
Hi all! I've found an issue I can't seem to figure out. DNA center warns me that the connection to the pxgrid on an ISE server has stopped working because of an expired internal certificate, but when I look at the internal certificate in DNA center i...
Resolved! terms need to undersatnd in DNA
hi all,i`m Biggenner with knowledge zero there are some terms I need o understand in Cisco DNA,what is the following:-- fabric fundamental - Loop back - local loop - border edge - border node - fabric node - border router - cp router - fusion router ...
Hi I am trying to create a QOS policy. I add one and name it and leave everything on the defaults (CVD Queuing Profile etc) then add some buildings to the site scope. When I then try and deploy or save as draft I get the following error: Error Saving...
I am new to the DNA Center and incorrectly created a set of HTTP(s) write credentials in Design-Network Settings-> Device Credentials. I then applied these credentials to a site and they got pushed to a 9200L switch and a 9800-40 WLC. The DNA Center ...
I am having connectivity issues with management/enterprise depending on my default gateway. Depending on which gateway I am using I will get connectivity and won't with the other port. Enterprise and Management are on different VLANs and different sw...
Resolved! DNAC how to not apply some templates
Hi So you can only have one network profile per building but how do I then only apply templates to a subgroup of devices? Say I have 50 9300 switches all physically the same model and IOS-XE version and I have templates A,B,C,D. Some of the switches ...
Resolved! DNA network config question
After several hours I keep coming back to the same issue. Assigning an IP to Fiber port (enp9s0) with10.10.10.1 / 24 - GW: 10.10.10.220 (HSRP address on cores for vlan 10), and DNS IP. I use this vlan for management of Cisco network devices and it h...
Hi, I'd like to create configuration (day-n) templates with some multiline commands. The <MLTCMD> doesn't provide me the correct output for:- interface macro's- banners (containing some special characters ($,"(),#,-) I tried #INTERACTIVE mode, but th...
Resolved! L3 border handoff SDA
we are building an SDA network with two Cisco9500 Border Nodes that are connected by BGP to a fusion firewall cluster (Fortigate). When DNAC configures the L3 border handoff it uses a /30 subnet between the Border Node and the external device, in my ...
Hi Everyone,I am working on integrating Cisco DNA Center and Service Now for event management subscriptions and was wondering if anyone knows the API payload that Cisco DNA Center sends to Service now when opening an incident? I am working with our i...
I am troubleshooting intermittent Device Health scores in DNA Center, and I am trying to locate the logs that will help me troubleshoot the issue. The Audit logs available through the interface don't appear to contain any information to help in this...
I have WLC and more AP running. Clip belowhttps://www.youtube.com/watch?v=NsMqUsVUTeo&t=303sWhen assign WLC to site, I see AP impersonation: Enable. I wonder if assign WLC to site have effect to AP running.
