Hi All. I have created new fabric network with DNA-Center from zero after our company had office migration and now I need help with completing Wide Area Bonjour installation. I had fabric network and Wide Area Bonjour installed in previous network, b...
Hi EveryoneI'm using the maglev wizard i.e. "sudo maglev-config update" to perform the initial configuration of a new DNAC appliance but after providing various items of IP address information at the appropriate prompts, I get the following error mes...
Hello everyone.I'm new to the Cisco U community. I heard about Cisco U on the Cisco Meraki community.So I have a Meraki Mx84 and Mx64, I would like to integrate Cisco U as my DNS. how to do it?thank you for everythingCisco U and Meraki Mx
I am trying to set up our lab DNA appliance but I don't have 10Gbps options. I saw in a document that the Enterprise port can run at 1Gbps. How do I do that? I have tried using a GLC-T but I haven't had any luck yet.
We get to know that during support renewal of hardware you must need to renew DNA licenses as well, no matter if you are delicately using DNA features or not. Cisco have no option to renew hardware support without renewing DNA licenses subscription w...
Hello. I would like to know if anyone knows of a way to get a report sent dy mail.As of now I have to go in and download the report, attach it to a mail and send it to the person who needs it. Due to the network structure we have excluded access for ...
I am setting up a DNA appliance for the first time and when I put in my CCO and link it to my smart account, it comes up with the wrong SA account. I am connected to multiple SA accounts with my CCO. How do I get the DNA appliance to recognize a diff...
Dear community, we are currently building a small SD-Access Fabric. Afterwards we tried to integrate an infoblox as IP address manager. When I try to apply the configuration under System Settings -> Settings -> IP Address Manager I get the failure co...
Hi there, We have recently labbed an SD-Access implementation using 9200L edge switches, only to be hit with this error when deploying multiple VNs to the fabric:Provisioning failed due to invalid parameter. Cisco Catalyst 9200L Switch Stack supports...
I have been going through the documentation to create a traffic copy policy for ERSPAN with DNA Center.https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/network-automation-and-management/dna-center/1-3/user_guide/b_cisco_dna_center_ug_1_...
Unable to enable the Embedded WLC on 9500's (Border Nodes) via DNAC.It is stuck in the "Image imported successfully" state and will not progress to the “Image activation” stateI have followed the following guide:https://www.cisco.com/c/dam/en/us/td/d...
hello,I have a switch 9500 which will be the border node of SDA fabric also I have two switches 9300 (no stack ) which will be two fusion routers, how I can ensure redundancy for the L3 handoff in my design Cdlt,
Can we integrate Cisco DNA-C with Cisco ACS?
Hello I would like to understand DNA Center's versioning nomenclature (as much as it pains me to say this ... it's 2020 and we have to try and understand a product's versioning because it's not obvious) When we refer to a DNA Center "version", wh...
Hi all,We have a deployment we cant really figure out why we cant create the actual Fabric. Under Provision, we only have devices and services, not fabric. All software packages are installed (SD-access is "Ready"), but still no Fabric-tab. Any clues...
