cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
151
Views
0
Helpful
2
Replies

DNA Center Reimage

bkengineer
Beginner
Beginner

Hi all,

I tried to re-image our dna appliance (2nd Generation) with version 2.2.3.5 but run into password issues and I need help.

I am able to complete initial wizard as listed in the installation guide release 2.2.3. After the installation, I am unable to login with the GUI password. CLI works. I tried accessing https://x.x.x.x:9004 and I only see advanced installation/configuration. When I follow the process, I get errors when I click configure.

I have done the installations a couple of times but always run into the same issue. I am every step in the guide but no headway.

Is there a new procedure and password I should use? FYI  (I am sure I am not mistyping the password).

Appreciate any leads.

2 Replies 2

Dan Rowe
Cisco Employee
Cisco Employee

What username are you using to login with?

bkengineer
Beginner
Beginner

Thanks to all. It was related to the keyboard layout.

Reimaging done successfully.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers