I have two DNA Cetners and on one when I create a discovery I have the option to select the Netconf port but on the other is says "No credentials to display".
Even on the one where it is there I cannot find where I configured it.
Anyone know where I can configure it?
Both running 22.214.171.124
Solved! Go to Solution.
Hope below URL help you :
DNAC Suggestion: would be cool just to configure this under Design > Network Settings > Device Credentials.
we will have to most likely enable netconf soon to do wireless at our FIAB sites since it appears at these sites we have to enable the wireless controller on the 9300 series switches we have at those sites.