cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
62
Views
0
Helpful
1
Replies

DNAC access point heat map layout

MC9
Beginner
Beginner

Hi all,

I am currently rolling out DNA center and have run into an issue. At one location I have a floor plan from the install team showing the location of all 100 access points. However, the APs are not labeled. I have imported the Cisco 5520 WLC and 3802 APs into DNA Center. Is there anyway for me to determine the correct AP is placed in the correct location on the floor plan?

 

Thanks!

-MC9

1 Reply 1

Dan Rowe
Cisco Employee
Cisco Employee

Unfortunately, no there is not. If you have the access points placed on the floor map in Prime Infrastructure, you can export that data from Prime Infrastructure into Cisco DNA Center. If this is not an option, the only way for you to be able to tell if the access points are placed correctly is by turning on the AP LED from the WLC and physically identifying the AP on the floor by the flashing LED.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers