08-17-2022 04:35 AM
Hi,
Some guidance / Help please!!!
I have a DNAC appliance running ver 2.2.3.5. It unexpectedly lost power, and when it was brought back online it went to a screen where the last message was "Press Enter for maintenance (or press Control-D to continue):" pressing enter takes you to a maglev console prompt "root@maglev-master-10:~#" and nothing works - Pressing Control-D has no effect!!
How do I recover this appliance without reinstalling from scratch???
Any suggestions would be appreciated!!
08-17-2022 10:45 AM
- Do you have any other command options available such as ? or help .
M.
08-19-2022 12:43 AM
Hi,
Yes, the maglev console still had commands but i had no idea which to run - I tried booting into Linux recovery mode and that broke everything - I'm re-installing from a flash drive AGAIN. Clearly these UCS servers don't play well with loosing power!?!?!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: