cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
723
Views
5
Helpful
3
Replies

IP Transit handoff configuration problem

rasmus.elmholt
Rising star
Rising star

Hi,

I have a pretty simple setup with a single 9300 Switch as C|B|E and configured 2 VNs on the device.

I am not trying to make a handoff towards a router but I cannot get the DNAC to bush the Border configuration to the device.

Every time I try it only gives me an error with:

Provisioning failed due to invalid parameter. The interface gigabitethernet1/0/24 on Device a6aa*******16 has an IP, remove the IP and then use the interface.

 

On interface Gi1/0/24 i have the following configuration and I have resynced the device:

interface GigabitEthernet1/0/24
 device-tracking attach-policy IPDT_MAX_10
end

Any advise would be appreciated.

1 Accepted Solution

Accepted Solutions

rasmus.elmholt
Rising star
Rising star

5 minuttes later everything worked.

View solution in original post

3 Replies 3

rasmus.elmholt
Rising star
Rising star

5 minuttes later everything worked.

Hi, nice it worked.
Just wanted to share a tip:
Have a look at Kibana (System Settings > Sytem 360 > Log Explorer) and search for: log:error AND <device ip address>
It will show you a more detailed error message - helped me a lot in such szenarios. (:

.:|:..:|:.Please rate helpful posts.:|:..:|:.

Looks like logs are not configured per default?

Looks like you don't have any logging indices.
Let's add some!

Or am I in the wrong place?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: