08-27-2020 09:13 PM - edited 08-27-2020 10:07 PM
Unable to enable the Embedded WLC on 9500's (Border Nodes) via DNAC.
It is stuck in the "Image imported successfully" state and will not progress to the “Image activation” state
I have followed the following guide:
However, stuck on page 16, Step 6 Once the image is imported and activated on the device, select the sites that are managed by the device.
DNAC: 1.3.3.7
C9500-16X-A: 16.12.3.s
Solved! Go to Solution.
08-28-2020 12:05 AM
This exact issue was raised on the SD-Access support forum a few days ago and appears to be the result of a bug in DNAC. See below.
Original post
First of all, the problem is due to a bug from version 1.3.3.6.
So the process, in DNA-C v1.3.3.7, would be, if the device is already in the fabric:
08-28-2020 12:05 AM
This exact issue was raised on the SD-Access support forum a few days ago and appears to be the result of a bug in DNAC. See below.
Original post
First of all, the problem is due to a bug from version 1.3.3.6.
So the process, in DNA-C v1.3.3.7, would be, if the device is already in the fabric:
08-28-2020 01:05 AM
Thanks willwetherman!
I should just direct message you from now on!
09-10-2020 05:50 PM
What about a scenario where the device was provisioned through PnP and no discovery was ever run?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: