Adding port informations via DNA Center Multivendor SDK

[MagnusLeonberger3073]

Hello everyone,

I want to know how i can get the Device 360° Interface Availabiliy, Tx and Rx Utilization/Errors Data to show up in the User Interface.I know how to access these data via the SDK, but i am missing the point where put them or how to map them.

[gayviswa · Accepted solution]

Device 360 and Tx/RX utilization and errors aren't supported with the SDK. Below is the level of support currently available for non-Cisco devices, supported using the SDK.

• Discovery
• Inventory
• Topology
• Basic Monitoring (CPU, MEM, UP/DOWN etc.)
• Command Runner