Hi all, We are currently in the process of planning the implementation of DNAC. I observed in the Cisco DNA Center Legacy Device Compatibility Matrix that N9K is supported, but I couldn't find information on its specific presentation or display effec...
Forum Posts
When we integrating the Meraki dashboard with DNAC , it will ask Token , So i am assuming its token based authentication using API calls.Similarly while integrating DNAC with ISE and Efficient IP , it will authenticate using username:password , So i ...
Hi guys,with the 1800S sensors having reached EoS is there any update on a potential successor ? We need deployed sensors to monitor RF issues in specific areas and are wondering if Cisco will come up with something new or if we need to focus on 3rd ...
Resolved! AP Power save with Cisco DNAC
Is there any chance to configure AP power save at off-peak hours through Cisco DNA Center.If yes, is it possible in Assurance or Automation ? Thanks in advance
I have a Cisco 5520 Controller that is in the inventory in DNAC but I do not have the access points that are in the WLC showing up in DNAC. WLC 5520= 8.2.190APs= 9130, 1815DNAC= 2.3.5.5-72026
Greetings all,I've been tinkering with DNA Center's AI RRM in some of our buildings and noticed some interesting results in that our wireless network health has degraded, particularly in higher density areas where we have a hospitality unit in each d...
Need some idea like which protocols in backend DNAC use to perform its discovery ,Will it uses SNMP, ICMP and SSH to do the discovery and to access them.
Both can ping each other through ICMP, NO FW/ACL in between. The ISE shows available but PXGrid unavailable. External auth works. Both ISE and DNA certs replaced with trusted inter and root. Look fine. Unsure what else to check, as I deleted and re-a...
Dear all, In my DNAC, I've successfully added my Smart Account credentials (System > Settings > Smart Account). I want to switch my credentials with other credentials but I get the following error: "Smart Account privilege check is failed. Smart Acco...
We recently adopted DNAC as a replacement for our wireless monitoring solution, and we will be gradually adding our AireOS and Cat9K WLCs into the system. I am looking at any built in capabilities that verify the following information shown below fo...
Under the Cisco DNAC in the Fabric Sites i am see the following error(alert ) message: There are configuration updates available for this SD-Access fabric site: 1 Critical Fix(es). Critical fixes should be applied as soon as possible. Click here for...
Hi All, We have generation 1 DNA Hardware appliance and we want all the configuration from that to be moved to Virtual DNA , Would it be possible , IF yes please help us with the backup restore process.
Resolved! DNAC and Meraki license
I hope this email finds you well. I wanted to reach out regarding our plan to onboard our Meraki environment in Cisco DNA Center (DNAC). We are excited about the potential benefits of integrating our Meraki devices with DNAC, but we have a question r...
hi all,in compliance status in DNAc, i have 2 setting :Fabric and Network Profilesin my switch they are always not compliance in both.i have 2 questions:-- what are they point to ?- how can i fix them ?
Hi All,So I know edge node behind edge node is possible but I have the following scenarioSo the seeding device discovers 4 switches it places everything in queue until Switch 1 is provisioned then it starts with switch 2.Until this point it is workin...
