Cisco Catalyst Center

Hi, Wondering if anyone has run into the following issue. Trying to migrate Prime to DNA center using the inbuilt PDMT but everything works except the WLCs will not migrate to DNAC. I've turned off SNMP v1 and v3 on the WLCs to no avail. One thing to...

We recently adopted DNAC as a replacement for our wireless monitoring solution, and we will be gradually adding our AireOS and Cat9K WLCs into the system.  I am looking at any built in capabilities that verify the following information shown below fo...

I feel this is a fundamental question, but i need to ask as a newbie here.  I have been trying to figure out how to edit a switch configuration once it has been discovered and onboarded into DNA Center.  Command Runner won't let me use any command to...

hi allis there anyway to check switch IOS before upgrade IOS from DNAc?i mean i need to upgrade my switch from DNAc, but i need first to check the availability for switch ( especially  in Stack ) as there are some switch are down or lost connectivity...

Hi,In DNA Center 2.3.3.7, I want to amend the ACL/contract that is the IPV4_PRE_AUTH_ACL for Low Impact mode to add another protocol/port.  When I click "Add Contract Action" I only get the option of bootpc, bootps or domain.  Are these options fixed...

Hello all,i would like to ask if anyone has tried to upgrade switch IOS (e.g. Cisco 9300 switch stacks) via Cisco DNAC.1. Max no of switch stacks that can be upgraded via DNAC2. Roughly how long it will take from DNAC to complete switch IOS upgrade f...

I hope this email finds you well. I wanted to reach out regarding our plan to onboard our Meraki environment in Cisco DNA Center (DNAC). We are excited about the potential benefits of integrating our Meraki devices with DNAC, but we have a question r...

hi all,in compliance status in DNAc, i have 2 setting :Fabric and Network Profilesin my switch they are always not compliance in both.i have 2 questions:-- what are they point to ?- how can i fix them ?