I already install DNA Center ver 2.3.3.7, but stub with status unhealthy servcies.how to resolv this?
Forum Posts
I have some EOL APs that are being refreshed by CW9166 APs, and I noticed that the CW9166 APs are not showing up in CCC once they are registered to the C9800 WLC. The old AP still shows up under inventory with 0.0.0.0 as the IP Address, I confirmed ...
Resolved! ISE and DNAC Integration
The Cisco ISE using an internal certificate for the Admin and the CA trust certificate is uploaded to Cisco ISE Trusted Certificates. When I try to connect DNAC to ISE, I received the error message below. Please advise
DNAC fails on provisioning brownfield devices that have TACACS configured. What is the intended/recommended workflow for using DNAC to manage brownfield switches? Should TACACS/AAA commands be removed in order to provision? This becomes problematic w...
Dear all,i have Cisco DNAC Center version running Version 2.3.5.4-70852 and continuing to provision new device via Plug and Play option in DNAC center. After assigning new device (C9800-L) to site and now able to enter information for.... Wireless m...
Hi All,I have 2 new C9500-24Y4C switches with ver 17.09.04 and network advantage licencing. I followed the seemingly straight forward commands to setup the stackwise virtual but I am getting the above error when I run the command "Stackwise-virtual l...
Hi All Currently have a situation where an existing VSS setup with 9600 needs to have more VSL links ,currently only have 2 but now wanting 4. To do this would it mean down time and a reboot as per below when you setup the links , or would you be abl...
Hello, In spite of what I've read in doc as DNA 5.3.3 can update switch in bundle or install mode, the update always fails on switch as DNA try to update them in install mode, even if they are configured in bundle mode. Once switch converted from bun...
Is it possible to send DNACs configuration Archives to an external Windows server or does this have to be Linux? I've searched but have only found information for a Linux server. Based on this I'm assuming only Linux is supported but I thought I'd as...
Resolved! Create new SSID - network profiles
Hi all. DNAC - 2.3.5.4WLC 17.9.4aHope someone is able to help me out here. Today we are using three SSIDs on all our branch offices (using one network profile) all good here. But now our management want a fourth ssid created that should be used only ...
Hello all,i have Cisco DNAC Center version running Version 2.3.5.4-70852 and trying to provision new device via Plug and Play option in DNAC center. With new WLC device name, serial number, Product ID: C9800-L-F-K9 and IP address appearing under Cis...
Hey, everyone. I'm trying to set a SD-ACCESS envionment follow this document. However I meet this error while set a L3 switch as a control plane. Failed to add device XXX.a.com to the Fabric Site/Zone. Please configure Loopback0 interface with an IP ...
Resolved! Cisco catalyst 8000 as a proxy server
Hi, Currently I need to configure the proxy server address in browser lan settings. So it is very difficult for me to configure the same in new pcs ( I need to do it one by one in new machines). So is there any way to configure my catalyst 8000 swit...
Resolved! remove stack member from 3850
i had a stack of 2 3850's. i took one switch out but now i cant run the no switch 2 provision command. says no "switch" command? Switch# Role Mac Address Priority Version State-----------------------------------------------------------------------...
Resolved! ISE PxGrid and DNA Center
Does Cisco ISE use the "Admin" certificate to connect to DNA Center ? not the PxGrid certificate ?What is the different between PxGrid Server and Client certificates ?
