Hello,we are currently in the process of converting our telephone system to Voice over IP and integrating it into our DNA Center. In addition to the hardware IP phones, we would also like to use the Jabber soft client. The problem is that IP traffic ...
Forum Posts
Hi, I am trying to install a DNA Center and use the 169.254.32.0/20 and 169.254.48.0/20 APIPA addresses as recommended in the documentation: https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/network-automation-and-management/dna-center/2...
I am having issues getting both the enterprise and the management ports to be reachable on my DNA appliance. I put the default-gateway on the management and static routes on the enterprise and the enterprise is reachable but the management isn't. If ...
I manually registered the switch. It's not blocked by a firewall. Because SSH is not availableRegistered with telnet.But what should I do if this message pops up? Device Connectivity Failure : NCIM12008: Connectivity to the device could not be esta...
HiI am trying (and failing) to provision our 5520 WLC from DNAC. When looking through the details, it shows failed on "WSA Certificate push failed".Any suggestions to try? Is this likely to be a DNAC issue or a WLC issue?Thanks
Cisco DNAC cannot get health from most NADS But It changes, so screenshot below shows that 10.32.21.5 gets health score of 10, but e.g. 10.32.22.5 says “no health” Then 10 minutes after, it says no health, but suddenly 10.32.22.5 that previously said...
Hi, how can I export raw config (unsanitized as in CPI) in last verison DNAC
I have a new implementation of Cisco DNA I'm working on without our VAR or Support (right now.) I'm trying to integrate ISE and I See this error below:I've tried to apply the same Root CA in DNAC and ISE. I've been fiddling with the Root CA on the IS...
Hi, Im getting this error code when trying to lan authomation: NCOB02069: Failed to install the certificate after 3 attempt: failed to import CA certificate-PKI error CA_CERT_PROCESSING_ERROR(14)Thank you.
Resolved! DNAC: can't perform lan automation
hello,Im getting this error code when im trying to start lan automation:NCND00006: The input payload contains an invalid key: lan.info.My DNAC version is 2.2.3.6thank you
Cisco Prime Infrastructure Vs Cisco DNA Center.........Brief.
I configured DNAC with three interfaces:Management - eno1 - 192.168.100.2/24 with VIP 192.168.100.1 - it's out of band network in my companyEnterprises - enp94s0f0 - 192.168.150.2/24 with VIP 192.168.150.1Cluster - enp94s0f1 - 192.168.20.2/24 with VI...
We would like to upgrade a DNAC from 2.2.3.3 to 2.2.3.6 (recommended version). DNAC is connected to cisco sites and it proposes the upgrade to the latest version. May we upgrade to 2.2.3.6 instead to the latest version? I cannot find how I may select...
Hello,I want to provision a new guest WLAN network by using DNAC.The Guest WLAN is based on ISE sponsored guest portal which does already exists on ISE.From what I know DNAC can only provision selfregistered or hotspot guest WLAN (and at the same tim...
