Cisco Catalyst Center

This community is for technical, feature, configuration and deployment questions. For production deployment issues, please contact the TAC!
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Don't miss this Cisco Catalyst 8000 offer

 

Forum Posts

Ask Me Anything Event   Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from  Friday, March 15, 2024 through Friday, April 5, 2024. Our colleagues Pandian Ponnuswamy, Gautami Sinai Neureker and Sankkar R will be wa...

pand.jpg akhi.jpg sankkar.jpg

Hi,I am new to DNAC and looking for some advice...I am going to change some APs and therefore I want to use the "Access Point Refresh" Workflow. I will provide the Serial Number of the new APs against each old AP. But there is one problem.It takes so...

Hi all, I am trying to set up Layer 3 handoff between cisco border node on one side and pair of FTD in HA mode on the other. The problem is that DNAC uses /30 subnet for P2P connectivity and I need minimum 3 IPs to use ( 1 on switch and 2 for active/...

M. G. by Level 1
  • 268 Views
  • 2 replies
  • 0 Helpful votes

So beginning with 2.3.3.4 the Add ip pool to virtual network has started to fail. We have been using this call in a script for a while now, but it now dislikes our names for the actual vlans. The structure that worked with 2.2.x.x was:{"siteNameHiera...

trondaker by Level 1
  • 572 Views
  • 4 replies
  • 0 Helpful votes

Hi everybody!We would like to explore and option to have a separate DNAC environment just for provisioning. The idea is for this to be isolated and only able to run our onboarding scripts.We don’t need any other DNAC features (Assurance, Analytics, e...

ewaizel by Level 1
  • 336 Views
  • 2 replies
  • 0 Helpful votes

Resolved! Dnac in cluster

I am about to configure a dna cluster ( 3 DN2‑HW‑APL 44 cores ) in the next few days together with ise. Any information about this configuration will be welcome. Thanks a lot Ciro Gustavo Mele.

Resolved! DNA Center HA

HI AllI wonder to know is that possible to configure DNA center High Availablity with two hardware appliance and one virtual appliance with the same core and same software version? Regards,

henockk by Level 1
  • 369 Views
  • 1 replies
  • 0 Helpful votes