C9500-32QCA reload power problem

[WalkerLena]

kindly i have problem that switch C9500-32QC that is working as border in SDA  is reloaded  without any reason or loggs , so kindly share your experience if you faced a similar problem

  all switches on the same rack are working fine

------------------------------------------------

Border-SW uptime is 1 hour, 28 minutes
Uptime for this control processor is 1 hour, 29 minutes
System returned to ROM by PowerOn
System image file is "bootflash:cat9k_iosxe.16.12.03s.SPA.bin"
Last reload reason: PowerOn

--------------------------------------

KSU-SH-Border1-SW#show power
Power Fan States
Supply Model No Type Capacity Status 0 1
------ -------------------- ---- -------- --------- -----------
PS0 C9K-PWR-650WAC-R AC 650 W ok good N/A
PS1 C9K-PWR-650WAC-R AC 650 W ok good N/A

Fan Fan States
Tray Status 0 1 2 3
------ ---------- -----------------------
FM0 ok good good good good
FM1 ok good good good good

KSU-SH-Border1-SW#

[Georg Pauwen]

Hello,

tough one. There are a couple of bugs, such as the one below, or 'ip multicast-routing' being configured on the switch.

Can you post the entire running config ?

Unexpected reload (or boot loop) caused by Smart Agent (SASRcvWQWrk2)
CSCvt41134
Description
Symptom:
The affected device might unexpectedly reload, or remain on boot loop, with the following errors:

- Segmentation fault at SASRcvWQWrk2:

UNIX-EXT-SIGNAL: Segmentation fault(11), Process = SASRcvWQWrk2

Conditions:
Triggered by this line of config: 'clock summer-time recurring'
It is caused when the timezone is written in expanded form rather than the abbreviated form.

Ex: "Pacific Standard time" instead of PST
"Central_DAYLIGHT_Time" instead of CDT

Workaround:
When configuring 'clock summer-time recurring' use 3-character string for

Ex: PST or IST or EST or CET