04-07-2022 12:26 PM
Hello everyone,
I have Cisco 2960G 24port
The switch's port takes 30 seconds to go up,
Is there any command to make it go up faster.
04-07-2022 12:38 PM - edited 04-07-2022 12:39 PM
04-07-2022 12:46 PM
Try to ajuste the forward delay.
Forward delay—The forward delay is the time that is spent in the listening and learning state. This time is equal to 15 sec by default, but you can tune the time to be between 4 and 30 sec.
SW-1(config)#spanning-tree vlan 1 forward-time 10
04-07-2022 04:54 PM
I gave the command in switch#config mode and gave do write but it didn't work still takes 30s to go up.
04-07-2022 05:12 PM
config the port as portfast this reduce the time to 15 sec. as doc. I attach.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: