Cisco SDA move phyiscal uplinks and add redundancy
I have a fully working SDA Fabric and the edge nodes were provisioned using lan automation from DNAC. Now I connected my Edge with port 1/0/24 to my border and control node on port 1/0/1. Now I want to move the uplink on border side to port 1/0/24 as well.
for better understanding:
Old: Edge 1/0/24 <-> CoBo 1/0/1
New: Edge 1/0/24 <-> CoBo 1/0/24
How can I do that? Do I need to manually copy the config on my border from port 1/0/1 to port 1/0/24? Or can I migrate it somehow using my DNAC?
And as additional question, let's say I want to add a secondary uplink to my edge from port 1/0/23 to 1/0/23 on my border. Do I need to configure this manually, or can I do that somehow with my DNAC as well?
OverviewCisco SDA Overview:Cisco ACI Overview:How the Integration works:Configuration:Topology:Cisco DNAC to ISE Integration:Cisco ISE to ACI Integration:Verification:Policy Enforcement in ACI Domain:Policy Enforcement in Cisco SD-Access Domain:
The long-awaited Cisco Catalyst 9600 Series switches are now here. As foundational building blocks for the Cisco Digital Network Architecture, Catalyst 9600 Series switches help customers simplify complexity, optimize IT, and reduce operational cost...
Inviting all Network professionals! We want you to tell us what devices you use to do your work and its screen resolution. Your response will help us improve network management tools.
Click here to take the 5-minute survey: http://cs.co/9009E28lV
Calling Cisco Customers who manage networks in your companies
We have a quick 5-minute survey for you to complete. Your response will help Cisco improve a product feature that could benefit you.
Click here now: http://cs.co/9002E0kjC
Since the last blog on IOS-XE release, there has been a standard maintenance release which was followed by the recently published Extended Maintenance Release(EMR) and the last release on the 16.x train, IOS-XE 16.12.1. With this being an EMR release, it ...