04-16-2019 10:05 AM
I just installed DNA center yesterday, and have been trying to set up access to CCO from the machine. When trying to get CCO,or any update server, what interface is it using? The Enterprise 10G interface or the GUI 1G interface? I need to make sure I have the correct ports opened in my firewall.
Solved! Go to Solution.
04-17-2019 05:28 PM
Hello,
DNA Centre will use whatever interface has the route towards the destination it's trying to reach - the routing table can be customised during DNA Centre setup.
Note here there is a single default gateway, and also static routes on a different interface:
To check your routing table on an already installed DNA Centre, from the CLI, you could use commands:
route --help
route -n
HTH, Jerome
04-17-2019 07:43 AM
04-17-2019 05:28 PM
Hello,
DNA Centre will use whatever interface has the route towards the destination it's trying to reach - the routing table can be customised during DNA Centre setup.
Note here there is a single default gateway, and also static routes on a different interface:
To check your routing table on an already installed DNA Centre, from the CLI, you could use commands:
route --help
route -n
HTH, Jerome
04-24-2019 07:42 AM
Thank you Mike and Jerome. The info helped me out.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: