cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1019
Views
5
Helpful
4
Replies
Highlighted
Cisco Employee

DNAC Interfaces

hi

 

All our documentation recommends using a separate interface for mgmt/Cloud updates & Enterprise (to access the network devices), however we have a customer for which it would be difficult to separate these 2 interfaces.

 

Is it ok to use the Enterprise link only or will we get in trouble with future updates?

Thanks

Gert

4 REPLIES 4
Highlighted

Hello,

 

Also interested to get the answer.

 

We have been told by Cisco that only enterprise and intra-cluster (as we cannot change anymore cluster link when configured) interfaces are mandatory. And mgmt were needed/interesting when we have an OOB network.

 

So if we need to connect other interfaces i am interested to know ... 

 

Thx,

Philippe

Highlighted
Beginner

Hi Gert,

 

I can see only two reasons why you should use both interfaces:

 

1) As Philippe already said, this is the only way to map access via an OOB network.

2) To avoid that the Enterprise Interface is congested when downloading updates etc. This could disrupt the communication between DNAC, ISE, routers and switches.

 

Best regards,

Johannes

Highlighted
Cisco Employee

Mgmt and Cloud ports are optional. Hence yes there are customers who use Enterprise port only. But it is not recommended by cisco.

Highlighted
Contributor

Short answer is if the customer is not using a cold standby DNAC at a different location, then it should be OK.

When you do cold standby then the enterprise port needs to be shut down on the cold standby interface until the primary fails and during that time cloud interface can be used by cold standby DNAC to  access internet and download updates etc.

-Rate helpful posts-