DNAC Network Telemetry Fail when apply a profile

[Elena.Madrigal]

Hello

Iam using DNAC 1.3.3.7 and i have create a Network settings with SNMP , netflow colectors and syslog,etc .. But when i applied the network profile, in the Telemetry secction show the following  error:

No non-eta enabled access switchports with description lan found

Anyidea about the reason?

Thank so much in advance

[Atul Patil]

Hi Elena,

Please refer attached document.

[Elena.Madrigal]

I had already read that guide, but nothing comes there.Thanks

Maybe the Assurance guide have a tip -"Resynchronize the network device to read this interface description. The Network Telemetry tool looks for interfaces with  the word lan in the description and applies the Application Visibility configuration to only those interfaces.

I will try this