cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Choose one of the topics below for Cisco DNA Center Resources to help you on your journey with Cisco DNA Center

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC!
We will not comment or assist with your TAC case in these forums.

370
Views
5
Helpful
2
Replies
Highlighted
Beginner

Layer 2/3 Aggregation Support on Cisco 9300 Network Essentials License

Hi Techguys, 

 

Any body have  configured Layer 3 Etherchannel on Cisco 9300 with network essentials License. 

switches model is. My assumpation is , its supports only Layer 2 etherchannel as of Layer 2 routed access port. 

 

C9300-48P-E

Catalyst 9300 48-port PoE+, Network Essentials

C9300 Network Essentials, 48-port license

 

 

Thanks in advance for your support

 

Everyone's tags (1)
2 REPLIES 2
Highlighted
Cisco Employee

Re: Layer 2/3 Aggregation Support on Cisco 9300 Network Essentials License

Hi, 

 

L3 port-channels are supported in Network Essentials:

 

Switch#sh ver | in Smart License
network-essentials  	Smart License                 	 network-essentials
None                	Subscription Smart License    	 None
Switch#sh run int po1
Building configuration...

Current configuration : 61 bytes
!
interface Port-channel1
 no switchport
 no ip address
end

Can you advise what error / issue you are getting on your side?

 

Regards, Mariusz

Highlighted
Beginner

Re: Layer 2/3 Aggregation Support on Cisco 9300 Network Essentials License

Thanks Mariusz  Kazmierski  for the Reply, 

I want to confirm as client wants Layer 3 etherchannle in access switches,  it was not Supported in old LAN BASE Software. 

Thanks for confirmation, 

 

 

CreatePlease to create content
Content for Community-Ad