02-02-2020 06:58 AM - edited 02-02-2020 09:29 AM
Hi Techguys,
Any body have configured Layer 3 Etherchannel on Cisco 9300 with network essentials License.
switches model is. My assumpation is , its supports only Layer 2 etherchannel as of Layer 2 routed access port.
C9300-48P-E | Catalyst 9300 48-port PoE+, Network Essentials | C9300 Network Essentials, 48-port license |
Thanks in advance for your support
02-02-2020 11:54 PM
Hi,
L3 port-channels are supported in Network Essentials:
Switch#sh ver | in Smart License network-essentials Smart License network-essentials None Subscription Smart License None Switch#sh run int po1 Building configuration... Current configuration : 61 bytes ! interface Port-channel1 no switchport no ip address end
Can you advise what error / issue you are getting on your side?
Regards, Mariusz
02-03-2020 12:05 AM
Thanks Mariusz Kazmierski for the Reply,
I want to confirm as client wants Layer 3 etherchannle in access switches, it was not Supported in old LAN BASE Software.
Thanks for confirmation,
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: