09-18-2019 05:48 AM
Hello,
I have a question about the trunk connection between border and fusion router .
when provisionning overlay network , DNAC implement vlan range start to 300X for the connection vlan/vrf of the VN .
this is mandatory or you can change this range ?
Solved! Go to Solution.
10-24-2019 05:36 AM
As @Jonathan Cuthbert mentioned you cannot change the 300x vlans that get assigned for EBN<-->FR. If you have dual EBNs & dual fusions you could use the 400x series for your connections between EBNs and then use 200x series vlans for FR <--> "legacy" connections. Just be aware that DNAC will provision the default voice vlan as 4000 and the default critical vlan as 2047. Good luck & HTH!
10-23-2019 08:42 AM
The VLAN ranges used for the Fabric overlay SVIs and for the Border Automation L3 Hand-off are not user configurable.
10-24-2019 05:36 AM
As @Jonathan Cuthbert mentioned you cannot change the 300x vlans that get assigned for EBN<-->FR. If you have dual EBNs & dual fusions you could use the 400x series for your connections between EBNs and then use 200x series vlans for FR <--> "legacy" connections. Just be aware that DNAC will provision the default voice vlan as 4000 and the default critical vlan as 2047. Good luck & HTH!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: