cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
922
Views
0
Helpful
1
Replies

Switch configs to point to DNA-C

Steve Bellan
Level 1
Level 1

Team, DNA-C cluster is installed and successfully discovered the subnets. Devices are communicating via SNMP. We are using for Assurance only to begin with. So the question is....to get the most from Assurance what else on the switch do we need to point to the DNA-C? SYSLOG? NetFlow?

 

ISE will be integrated soon

1 Reply 1

Preston Chilcote
Cisco Employee
Cisco Employee

3 suggestions:

 

1) Take advantage of Cisco Customer Success Ask-the-expert webinars.  They are free and cover all sorts of topics that might be of interest to getting the most out of DNA-C

https://learningnetwork.cisco.com/community/learning_center/cisco-dna-ask-the-experts

 

2) Bookmark this page, "DNA Getting Started", and review any Assurance trainings that sound helpful:

https://www.cisco.com/c/m/en_us/products/cloud-systems-management/dna-center/getting-started.html

 

3) Enable application visibility following the instructions here:

https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/network-automation-and-management/dna-center-assurance/1-3-1-0/b_cisco_dna_assurance_1_3_1_0_ug/b_cisco_dna_assurance_1_3_1_0_chapter_01001.html

 

The telemetry profiles built into DNA-C will do the necessary syslog/netflow/application monitoring configs for you!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: