Hello,
I'm facing a big problem with my DNA center 2nd génération appliance.
My Appliance was shiped with pre-configured software 1.3.0.6 and now it'is upgrated to 1.3.1.5. All functions seem to be installed correctelty and no hardware problem.
the only problem that i'm facing ( is the only and big problem) is that the Entreprise port can't reach my Subnets ( internal network : 10.0.0.0/8 For Data, 192.168.10/24 For servers). I DNA Center network configuration is as following:
Entp port (ENP94S0F0)
IP : 192.168.128.240
Netmask : 255.255.255.0
Default-gateway 192.168.128.254
DNS :blank
Mangement Port (eno1):
IP : 10.3.0.240
Netmask : 255.255.255.0
Default gateway IP address : Blank
DNS servers : 192.168.10.10 192.168.10.20 192.168.10.63
Static routes:
192.168.0.0/255.255.0.0/10.3.0.254
10.0.0.0/255.0.0.0/10.3.0.254
Cluster port ( ENP94S0F1)
IP : 192.168.129.240
Mask : 255.255.255.0
Default gateway : Blank
X Cluster
CIMC Port : Another subnet ( 10.3.2.10/24)
My Subnets adress pool for pnp automation will be on 10.0.0.0./8
After throublshooting with ping :
Ping sourced from Subnets 10.0.0.0/8 or 192.168.0.0/16 to Ent port or Cluster port Doesn't replay.
Ping sourced from subnets 172.16.0.0./12 to Enterprise port == Ok, it's replay , Cluster port doesn't replay
I Relased that the satics routes configured on the Mangement (GUI) port take precedence over the default routes.
My question are :
1- How can i do the correct configuration for default-gateway and for statics routes ( can someone give explication using my config) ?
2 - Cisco say that we can change IPs and statics routes after deployement. Now i'm using sofware 1.3.1.5, Can somesone confirm that, and which Command should we enter ?
Thanks in advance
