The correct configuration of the Gateway and statics routes
I'm facing a big problem with my DNA center 2nd génération appliance.
My Appliance was shiped with pre-configured software 220.127.116.11 and now it'is upgrated to 18.104.22.168. All functions seem to be installed correctelty and no hardware problem.
the only problem that i'm facing ( is the only and big problem) is that the Entreprise port can't reach my Subnets ( internal network : 10.0.0.0/8 For Data, 192.168.10/24 For servers). I DNA Center network configuration is as following:
Entp port (ENP94S0F0)
IP : 192.168.128.240
Netmask : 255.255.255.0
Mangement Port (eno1):
IP : 10.3.0.240
Netmask : 255.255.255.0
Default gateway IP address : Blank
DNS servers : 192.168.10.10 192.168.10.20 192.168.10.63
Cluster port ( ENP94S0F1)
IP : 192.168.129.240
Mask : 255.255.255.0
Default gateway : Blank
CIMC Port : Another subnet ( 10.3.2.10/24)
My Subnets adress pool for pnp automation will be on 10.0.0.0./8
After throublshooting with ping :
Ping sourced from Subnets 10.0.0.0/8 or 192.168.0.0/16 to Ent port or Cluster port Doesn't replay.
Ping sourced from subnets 172.16.0.0./12 to Enterprise port == Ok, it's replay , Cluster port doesn't replay
I Relased that the satics routes configured on the Mangement (GUI) port take precedence over the default routes.
My question are :
1- How can i do the correct configuration for default-gateway and for statics routes ( can someone give explication using my config) ?
2 - Cisco say that we can change IPs and statics routes after deployement. Now i'm using sofware 22.214.171.124, Can somesone confirm that, and which Command should we enter ?
Listen: https://smarturl.it/CCRS9E24 Follow us: https://twitter.com/CiscoChampion
Cisco Radio Aware Routing addresses several of the challenges faced when merging IP routing and radio communications in mobile networks, especially those exhibiti...
Listen: https://smarturl.it/CCRS9E23 Follow us: https://twitter.com/CiscoChampion The Wi-Fi 6E Catalyst 9136 access point takes advantage of the 6-GHz band to produce a network that is more reliable and secure, with higher throughput, more ...
When moving from OSPFv2 to OSPFv3, there are many changes in the format of the LSAs Type, but the most known changes are: IP prefix informations are no longer carried in Type-1 LSA and Type-2 LSA, new LSAs Type 8 and 9 are added to carry these prefixes.
Read a preview of my book OSPF The ultimate for CCIE Enterprise and Infrastructure exam in Books Google Doc.
Read a preview of my book OSPF The ultimate for CCIE Enterprise and Infrastructure exam in Books Google Doc #CCIE #Cisco #exam #Enterprise ...
Question 1: What are the OSPF Loop Prevention Mechanisms
In single area, the routers have the Link State Database, having the same LSDB helps the routers to build a loop-free topology.
Now in a multiarea topology, the ABRs are respon...